Phones answered 24/7Janesville, WI
Call (833) 490-5225
(833) 490-5225
Guide

Drying Out After the April 2026 Rock County Flood

The April 2026 flash flood put feet of water through Janesville streets. Here is how drying out, mold risk and the paperwork work once the water drops.

Illustration for the guide "Drying Out After the April 2026 Rock County Flood" (Janesville, WI)
Short answer

Flash flooding on the night of April 17, 2026 put three to four feet of water through some Janesville streets and damaged hundreds of buildings across Rock County. Once water drops, the order of work is extraction, removing contaminated porous material, cleaning, then measured drying and documentation.

Key takeaways

  • Flash flooding on the night of April 17, 2026 swamped cars, houses and businesses in Janesville and hit Traxler Park badly.
  • The Rock River gauge at Afton crested around 12.11 feet on April 18 on a provisional reading, against a major-flood level of about 12.2 feet.
  • Rock County's early damage counts were preliminary and were revised, so the honest summary is that hundreds of buildings were damaged.
  • River and street flood water is treated as contaminated, which decides what can be dried and what has to be removed.
  • The 2008 record crest of 13.51 feet at Afton shows this is a repeat exposure, not a one-off, for low-lying parts of the city.
  • Mold grows on wet organic material within days, so the drying window after a flood is short and measured rather than judged by feel.
  • Flood water is not covered by a homeowners policy; separate flood cover is what answers for it, and the Office of the Commissioner of Insurance is the state insurance regulator.

What happened in Janesville in April 2026?

On the night of April 17, 2026, flash flooding pushed three to four feet of water through some Janesville streets, swamping cars, houses and businesses, with Traxler Park badly hit. The Afton gauge on the Rock River crested around 12.11 feet the next day, provisionally.

Rock County's first counts of destroyed, major, minor and affected buildings were revised within days, which is normal for a rapid damage assessment and a good reason not to repeat any single figure as settled. What is clear is the scale: hundreds of buildings across the county took damage. For householders, the number that mattered was the one on their own basement stairs.

A night-time flash flood is the hardest version of this event. Nobody is watching a sump at two in the morning, cars are parked where the water goes, and the first look at the damage happens in daylight after the water has already soaked everything it is going to soak. That is why so much of the work described below is about what to do on the morning after rather than during.

How does this compare with the 2008 flood?

June 2008 was higher and slower. The Rock River at Afton crested at 13.51 feet on June 21, 2008, the highest in the modern record, topped the downtown seawall and destroyed homes in a low-lying subdivision on the northwest side, with federal money later paying for repairs including a flood wall.

Comparing the two is useful for one reason: it tells a homeowner that this is an exposure with a history, not a freak. A property that took water in 2008 and again in 2026 is a property where the next decision about finished basement space, mechanical placement and flood cover should be made with both events in mind. The National Weather Service notes that at around 11.1 feet at Afton, floodwater reaches Riverside Park and a road inside it on the north side of the city, which gives a concrete marker well below either crest.

Elsewhere in the county the record sits differently. Turtle Creek crested at 13.95 feet at Beloit on June 27, 2013, the highest observed there, with basement water in some homes, and the Easter weekend flood of April 20 and 21, 1973 covered forty blocks of Beloit and South Beloit, left hundreds homeless and took one life. On the Rock upstream, Lake Koshkonong floods at 10 feet and is in major flood above 11.5, with the Malwood subdivision in the Town of Milton and roads including Vets Lane, Blackhawk Island Road and Oxbow Bend Road going under at higher stages.

What is safe to do on the first morning?

Check the structure and the power before the contents. Do not enter standing water near live circuits, do not run submerged mechanicals, wear boots and gloves, and photograph everything before anything is moved or pumped.

Treat flood water as contaminated whatever it looks like. Water that has crossed streets and yards carries sewage, fuel, fertiliser and whatever was in the garage, and it leaves that behind in carpet pad, drywall paper and insulation. Keep children and pets out of the affected area entirely. If a furnace, water heater or electrical panel has been underwater, leave it off and have it inspected before anyone energises it.

Then photograph. The waterline on the wall, the stair riser, every room, the contents, the data plates on mechanicals. These images are the only record of the flood at its height and they take ten minutes. Write down the date and time the water arrived and what you saw, while it is fresh. After that, pumping and extraction can start.

What comes out of the house and what can be dried?

After contaminated flooding, saturated porous material generally comes out: carpet and pad, fibrous insulation, the lower band of drywall, particleboard and soaked upholstery. Solid materials such as framing, plaster, masonry and solid wood are usually cleaned and dried in place.

The rule behind this is simple. Anything that absorbs water and cannot be thoroughly cleaned inside its own structure has to go, because drying it leaves the contamination where it was. Drywall is cut back above the waterline so the cavity can be flushed with air, insulation behind it is pulled, and the framing is cleaned and dried from both sides. A finished basement, which many homes along the low ground here have, loses more than an unfinished one for exactly that reason.

That makes the decisions easier to live with if you know them in advance. The things people most want to save, such as a carpet or a sofa, are usually the ones that cannot be saved; the things that look worst, such as blackened framing or stained block, are usually the ones that can. Photograph and list what leaves, and hold valuable items an adjuster might want to see rather than putting them straight on the kerb. Flood water extraction and pumping explains the removal stage in more detail.

How long does drying out actually take?

Days rather than hours, and the end point is measured, not felt. Air movers and dehumidifiers run continuously while a crew takes daily moisture readings in materials and keeps going until each one reaches a dry standard, which can take longer in plaster and in masonry.

Expect equipment in the house for several days and expect it to be noisy and warm. The aim is not to make the surface feel dry; it is to pull water out of the depth of the material and out of the cavities behind it. That is why a crew drills, lifts, pulls trim and dries assemblies from both sides, and why readings are taken in the same spots each day so progress can be seen.

Older Janesville houses can take longer. Where a basement has plaster over lath, a rubble-stone or block foundation or a wood floor over a crawl space, water has more places to hide and masonry gives it up slowly. A house whose median-era counterpart from the early 1970s dries in a few days may need more. The log of readings is what tells you when it is finished, and you should ask for a copy. Our structural drying and dehumidification page covers the method.

When does mold become the problem?

Quickly. Mold grows on wet organic material within days, so the risk is set by how long material stayed wet rather than by the flood itself. Material removed and dried promptly rarely becomes a mold job; a wall left damp behind an intact surface often does.

The warning signs show up weeks later: a musty smell that returns when the house is closed up, a patch of drywall that stays cool to the touch, paint that blisters along a base run, allergy symptoms that are worse indoors. Those point at a cavity that never fully dried rather than at the visible surface. A moisture meter settles it in minutes where a nose only suspects.

Wisconsin issues no license specific to mold remediation, so the questions to ask are about method: what is being contained, what is being removed, how the air is handled and how the result is verified. If the house was dried to a documented standard in the first place, most of this never arises. Where it does, mold after water damage sets out the approach.

What does insurance do with flood water?

A homeowners policy generally does not cover flood, which is why river and street water from April 2026 is answered by separate flood cover rather than by the policy that would pay for a burst pipe. Sewer and sump backup is a third category, needing an endorsement.

That split is the hard news for many households after an event like this one, and it is better understood before the next storm than during the clean-up. Whatever cover you hold, the regulator's consumer guidance is the same in practice: photograph the damage, notify your insurer promptly and do not discard damaged property until the adjuster has approved it. Documentation that is good enough for a claim is also good enough for an assistance program or a tax question later.

This guide names the Wisconsin Office of the Commissioner of Insurance as the state insurance regulator and quotes no deadline, limit, statute or figure from any policy. Our guide to water damage insurance claims walks through the documentation in order, and sewer and sump backup cover covers the endorsement question.

What should a flooded household change before the next one?

Move what you can out of reach of water, make the pump and its power supply reliable, and decide what the lowest level of the house is for. Those three choices do more than any single purchase after a flood like this.

Raising or relocating mechanicals, putting storage on shelving rather than the floor, choosing hard flooring and removable base trim for a basement, and keeping an eye on grading and downspouts all reduce what the next event can take. Where a sump is the only defense, its float, its discharge line and what happens when the power goes out are worth checking before thunderstorm season rather than during it.

The seasonal calendar here is predictable even when individual storms are not: freeze and ice-dam risk from December into February, snowmelt and the spring rise on the Rock through March and April, then thunderstorms and flash flooding from May into August, which is where both 2008 and 2026 sit. Janesville Water Damage Restoration answers calls around the clock and dispatches a crew as soon as one is available, and the quietest months are the right time for the questions rather than the work.

Frequently asked questions

How high did the Rock River get in April 2026?

The gauge at Afton crested at about 12.11 feet on April 18, 2026, on a provisional reading, against a major-flood level of roughly 12.2 feet. Reports of the exact figures varied slightly while the data was still provisional. For comparison, the modern record at that gauge is 13.51 feet, set on June 21, 2008.

How many buildings were damaged in Rock County?

Early county counts of destroyed, major, minor and affected buildings were revised within days, so the figure that can be stated honestly is hundreds of buildings damaged across the county. Rapid damage assessments are preliminary by design. If you need a figure for a form, ask the county for its current assessment rather than relying on an early news total.

Can I dry a flooded basement myself with fans?

Household fans move air but do not remove water from the depth of materials, and they cannot verify that anything reached a dry standard. After contaminated flood water there is also the question of what has to be removed rather than dried. Extraction, removal of saturated porous material, cleaning and measured drying with dehumidification is the sequence that actually finishes the job.

Is flood water really contaminated even if it looks clear?

Treat it as contaminated. Water that has crossed streets, yards and storm drains carries sewage and chemical residues regardless of how it looks, and it deposits them in whatever it soaks. That is why porous material in the water is generally removed rather than dried, and why protective footwear and gloves matter during the clean-up.

My house flooded in 2008 and again in 2026. What does that mean?

It means the exposure is recurring, and decisions about the lowest level of the house should be made on that basis. Keeping mechanicals and storage above the reach of water, choosing finishes that can dry or be replaced cheaply, and reviewing what flood cover you hold are the three practical responses. The 2008 crest at Afton was higher than 2026, so the earlier waterline is the more useful planning mark.

How soon after a flood should the drying start?

As soon as the water has dropped and it is safe to work, because mold grows on wet organic material within days and every extra day moves more material from dryable to removable. Photograph the damage first, which takes minutes, then begin extraction. Notify your insurer the same day even if you are unsure what your cover includes.

Sources

  1. NOAA National Water Prediction Service
  2. National Weather Service
  3. Wisconsin Office of the Commissioner of Insurance
  4. City of Janesville

This guide is general information for Rock County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what help should cost.

Keep reading

More guides

WhatsApp