Phones answered 24/7Janesville, WI
Call (833) 490-5225
(833) 490-5225
Guide

Rock River flood water in the house: the first hours

River water in a Janesville house counts as contaminated. What to do in the first hours, how the drying window works, and which materials normally leave.

Illustration for the guide "Rock River flood water in the house: the first hours" (Janesville, WI)
Short answer

Treat river water as contaminated, keep people out until power is isolated, and get the standing water pumped before anything else. Drying cannot start while water stands, and the porous materials the river touched are usually removed rather than dried. Photograph every room before anything moves.

Key takeaways

  • The Afton gauge on the Rock River crested at 13.51 feet on June 21, 2008, the highest modern reading, and water came over the downtown seawall.
  • The National Weather Service notes that at 11.1 feet at Afton floodwater reaches Riverside Park and a road inside it on the north side of Janesville.
  • Flash flooding on the night of April 17, 2026 put three to four feet of water through some city streets, and Afton crested near 12.11 feet on April 18 on provisional data.
  • River and street water is handled as contaminated, which decides what is dried and what is removed far more than the depth does.
  • Pumping, then extraction, then airflow, then readings: drying is measured, not estimated by feel.
  • River flooding needs separate flood cover and is not part of a standard homeowners policy.

What should you do in the first hour after river water enters?

Get everyone out of the wet area, have the power to those circuits isolated before anyone wades, and call for pumping. Then photograph every room from the doorway inward. Nothing else you do in that hour pays off as reliably as those three things.

Electricity and standing water are the reason the first instruction is to stay out rather than to start bailing. If the panel is in the flooded basement -- common in this city's older houses -- do not go to it; have the supply cut from outside or by the utility. Gas appliances that have been underwater, including a water heater or a furnace, are not to be relit by the homeowner. These are small decisions that have outsized consequences, and they come before any thought about carpet.

Once the area is safe to enter, the clock that matters is the one on the standing water. Pumps move the bulk, then extraction equipment pulls what is left out of the carpet and off the slab, and only then does airflow accomplish anything. Photographs taken before any of that happens are the record of what the water actually did, and they take two minutes. Call (833) 490-5225 once the area is safe; crews go out for water around the clock as fast as one is free.

How high does the river have to get before houses take water?

The National Weather Service notes that at 11.1 feet on the Afton gauge, floodwater reaches Riverside Park and a road within it on the city's north side. Major flood level there is around 12.2 feet. Street flooding from heavy rain, though, does not wait for the gauge.

Two readings give the scale. On June 21, 2008 the Afton gauge crested at 13.51 feet, the highest in modern record. The river went over the downtown seawall, several homes in a low-lying subdivision on the northwest side were destroyed, and roughly 60 homes across Rock County were damaged according to a local retrospective rather than an official count. Federal money later paid for repairs including a flood wall along the river. On April 18, 2026 the same gauge crested at about 12.11 feet on provisional data.

The gauge is not the whole story, and that is the practical point for a homeowner. The April 2026 damage in Janesville came mostly from the flash flooding the night before the crest, when three to four feet of water moved through some streets in hours and Traxler Park was badly hit. Hundreds of buildings across the county were affected. A house can be dry at a river stage that sounds alarming and swamped by a storm that never shows up on a river chart at all.

Local river and creek readings a Rock County homeowner may hear referenced
Gauge or placeReadingWhen
Rock River at Afton13.51 ft, highest in modern recordJune 21, 2008
Rock River at AftonAbout 12.11 ft, provisionalApril 18, 2026
Rock River at Afton11.1 ft reaches Riverside Park and a road in itNWS threshold
Lake KoshkonongFlood stage 10 ft; major above 11.5 ftNOAA gauge
Turtle Creek at Beloit13.95 ft, highest observedJune 27, 2013

Why is river water treated differently from a burst pipe?

Because of what is in it, not how much of it there is. Water that has crossed yards, streets and storm drains carries soil, fuel residue and whatever the drains held. Porous materials that absorbed it are normally removed, because cleaning them to a safe standard is not realistic.

Clean water from a supply line is a drying problem. Contaminated water is a cleaning problem with a drying problem inside it. The distinction decides most of the scope: carpet and pad, fibreglass insulation, particleboard and the lower band of drywall are usually taken out when river or street water has reached them, while framing, concrete and solid subfloor can be cleaned, treated and dried in place. That is why two houses with the same waterline can get very different scopes if one took clean water and the other took the river.

It also changes what you should handle. Soft goods that sat in flood water -- upholstered furniture, mattresses, pet bedding -- are generally not salvageable, and handling them without protection is an avoidable risk. Keep them where they are until they are photographed and, if you are filing a claim, until an adjuster has approved disposal. Wisconsin's insurance regulator, the Office of the Commissioner of Insurance, makes that last point plainly: do not discard property before the adjuster has seen it.

What is the drying window, and why does it close?

Materials that stay wet begin to change rather than simply hold water: drywall loses strength, wood swells and separates, and microbial growth starts within days. Each day the water sits moves items from the dried column to the removed column, which is why extraction is urgent even when the loss looks cosmetic.

The window is not a single deadline, it is a slope. In the first hours, nearly everything non-porous and much that is porous can be saved if the water was clean. Over the following days, swelling and delamination make the same materials unsalvageable, and warm weather shortens the slope considerably. Southern Wisconsin's flash-flood season runs from May into August, which is also when a closed-up house dries slowest, so a June basement left for a long weekend is close to the worst case.

This is also where the honest limit of self-help sits. Household fans move surface air and do very little about moisture inside framing or under a floating floor. Commercial dehumidification and directed airflow are what pull water out of the structure, and the job is run against readings taken over several days rather than against how the floor feels underfoot. If nobody is taking readings, nobody knows whether the window has closed.

What usually survives river water and what usually does not?

Dense, non-porous and cleanable things usually survive: framing, concrete, solid wood that is dried promptly, metal and glass. Porous things that absorbed contaminated water usually do not: carpet pad, fibreglass batts, particleboard, soft furnishings and drywall below the line.

The reasoning is consistent even when the outcome feels harsh. A material survives if it can be cleaned to a safe condition and then dried to a measured standard. Framing lumber can be washed, treated and dried, and its readings can be verified. Carpet pad cannot: it is designed to hold things, and what it holds after a flood cannot be rinsed out of it with any confidence. The same logic condemns fibreglass insulation, which traps contaminated water against the inside of a wall cavity and hides it.

Drywall is the one that surprises people, because it is cut higher than the visible line. Gypsum wicks moisture upward well past where the stain stops, so a cut is normally made above the measured wet height rather than at the tide mark. That is not wasteful; it is the only way to be sure the wall cavity behind the new board is dry and clean when it closes up.

Typical outcome for materials after river or street water
MaterialUsual outcomeReason
Carpet and padRemovedPorous and held contaminated water
Fibreglass insulationRemovedTraps water inside the wall cavity
Drywall below the lineCut above the measured wet heightWicks moisture past the visible stain
Framing and solid subfloorCleaned, treated, driedDense and can be verified with readings
Concrete and blockCleaned and driedNon-porous enough to clean to standard
Upholstery and mattressesRemovedCannot be cleaned to a safe standard

Does homeowners insurance cover Rock River flooding?

Generally not. Flood needs separate cover, and foundation seepage is not covered on a standard homeowners policy. Sewer or sump backup, which often accompanies a flood, is usually excluded too unless an endorsement was added. Confirm what you hold with your own insurer.

This matters in the first day rather than later, because the cover you hold affects who you notify and how the paperwork runs. Wisconsin's Office of the Commissioner of Insurance publishes consumer information on what a homeowners policy does and does not reach, and on the backup endorsement in particular. Reading that before an event is better than reading it with a wet basement, but either way it is the regulator's own material rather than a contractor's description of your policy.

Whatever the answer turns out to be, the documentation advice is the same: photograph the damage, notify the insurer promptly, and keep damaged property until an adjuster has approved disposal. Those three steps cost nothing and are hard to recover if skipped. They apply whether the water came from the river, the street or a drain, and they apply even if you later decide not to file.

What about Lake Koshkonong, Turtle Creek and the rest of the county?

Rock County has more than one water story. Lake Koshkonong north-east of Milton floods at 10 feet and reaches major stage above 11.5 feet, and Turtle Creek at Beloit set its highest observed reading at 13.95 feet on June 27, 2013.

Around Lake Koshkonong, the Malwood subdivision in the Town of Milton is prone to flooding, and Vets Lane, Blackhawk Island Road and Oxbow Bend Road go under at higher stages. That is a slower kind of flooding than a Janesville flash flood: lake levels build and hold, which means long exposure for anything below grade and a drying stage that cannot begin until the water drops. Houses there often need pumping scheduled around the level rather than finished in one visit.

Downstream, Beloit and Turtle Creek have their own record. The Easter weekend flood of April 20 and 21, 1973 covered 40 blocks of Beloit and South Beloit, left hundreds of people homeless and killed one person. In June 2013 Turtle Creek crested at 13.95 feet at Beloit, its highest observed level, with basement water in some homes; the Clinton-area record of 12.85 feet still dates from 1973. South Beloit is across the state line in Illinois, so Wisconsin agency guidance does not apply to houses there.

How long does a flooded house take to dry out?

Days rather than hours, and the end is a reading rather than a date. Equipment runs continuously while a technician returns to measure framing, subfloor and wall cavities. Humid summer weather, deep saturation and dense materials all lengthen the schedule.

A realistic sequence after a river event is pumping and extraction on the first visit, removal of condemned materials next, then several days of dehumidification and directed airflow with return visits for readings. Cleaning and treatment of the surfaces that stay happens in that window. The rebuild -- drywall, trim, flooring -- waits until the readings are where they need to be, because closing a wall over damp framing is how a second, worse problem gets built in.

Expect the schedule to be revised at least once. Flood losses reveal themselves gradually: water found behind a stair stringer or under a floating floor on day three changes the plan. A crew that updates you when that happens is doing the job properly. What should not change is the standard the job ends at, which is a measured dry reading rather than a tidy-looking room.

Frequently asked questions

Can I pump my own basement out after the river goes down?

Sometimes, but only after the power to that area is isolated and only if you keep out of the water yourself while a pump is running. The bigger limitation is what pumping achieves: it moves the standing water and leaves the saturated materials behind. Extraction and measured drying are the parts that decide whether carpet, drywall and subfloor stay in the house, and household equipment does not do them.

Is it safe to use the furnace or water heater afterwards?

Not until they have been checked. Gas appliances that have been in flood water should not be relit by a homeowner, and electrical equipment that was submerged needs assessment rather than a test switch-on. This is also why drying a flooded basement by running the heating is a poor idea: the appliance may be compromised, and warm damp air in a closed basement is not drying anything.

Why is the drywall being cut higher than the water reached?

Because gypsum pulls moisture upward past the point the stain stops. Cutting at the visible line leaves wet board in place, and the wall cavity behind it stays damp after the room looks finished. The cut is made above the measured wet height so that the cavity can be cleaned, dried and verified before new board closes it in.

The water was clear. Does that mean it was clean?

No. Clarity has little to do with category. Water that has crossed a street, a yard or a storm drain is handled as contaminated regardless of how it looks, because the concern is what is dissolved and suspended in it rather than what is visible. The source, not the appearance, decides how the materials are handled.

We are outside the city. Does any of this change?

The method does not, but the circumstances do. A lake-influenced property near Koshkonong may need pumping staged over days while levels fall, and a rural property may be relying on a private well and a septic system, both of which have their own post-flood checks. Houses in South Beloit are in Illinois, so Wisconsin agency guidance does not apply to them.

Should I throw out ruined furniture before the adjuster comes?

No. Photograph it, move it out of the way if that is practical, and keep it until the adjuster has approved disposal -- that is what Wisconsin's insurance regulator advises. Discarding items early removes the evidence that they existed in the condition you are describing. Documenting first and disposing second is the order that protects you.

Sources

  1. NOAA National Water Prediction Service
  2. National Weather Service
  3. Wisconsin Office of the Commissioner of Insurance

This guide is general information for Rock County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent help, send the form and we'll call you back.

Keep reading

More guides

WhatsApp